– 3 –
Position of Damper Guide and Cable Holder Holding Screw
6
Cable holder holding screw
6
6
1
3
2
6
4
5
6
Damper Adjuster Marking Position
7
7
8
64
Countersink hole
Damper guide
holding screw
Assembling.Instruction
1. ③ Perform additional processing on damper guide ③ as shown in the drawing left below.
2. Fasten damper guide ③ on damper adjuster ② with four of screw ④ .
3. Fasten damper adjuster ② on control box assy ① with two of screw ⑥ .
. . ＊ With.a.black.felt.pen,.mark.the.position.of.the.damper.adjuster.as.shown.in.the.drawing.below.
4. Wire the cable and fasten the cable holder ⑤ with one screw ⑥ .
5. Attach Himelon ⑦ on two of the round holes of the rod holde.
6. Attach Himelon ⑧ on the area where the screw end ④ of the HP PWB assy touches.
Additional.processing.on.damper.guide
＊ .Place.the.countersink.holes.face.up,.as.shown.in.the.drawing.below,.then.cut.a.length.of.
64.mm.from.the.right.end..
【A-5】Contol Box (2)
No.
Description
Description
Remarks
PN
1. Control.Box.Assy.
Control.box.assy
See.A-5.(1)
2. Damper.Adjuster.
Damper.adjuster
909475.
3. Damper.Guide.
Damper.guide
TM-216-2.(64mm.Cut)
950711.
4. SCREW.
+.Flat.machine.screw.
M2.x.6.
798901.
5. Cable.Holder.
Cable.Holder
909483.
6. +.BINDING.TAPTITE.SCREW.
S.TITE.
+.Binding.taptite.screw.S.tite M3.x.6.Black
812271.
7. HIMELON.
Himelon
0.5.x.4.x.17.5.
816602.
8. HIMELON.
Himelon
0.5.x.4.x.35.
816602.
