– 30 –
3
2
1
4
Strike
↓
drops smoothly
1
3
↑
←
1
Rod
Controller Cover Assy
↓→
→
↓
↑
←
Assembling.Instruction
1. Press fit push latch ② to rod support assy ① .
2. Insert slide guide assy ③ on rod support assy ① , and adjust the smoothness of the rod.
＊ Follow.the.adjusting.instruction.shown.in.the.drawing.below.
3. Insert panel spring ④ , slide guide assy ③ on the rod, and press fit slide guide assy ③ to fix on the
push strike.
＊ Do.not.change.the.combination.of.rod.support.assy.①.and.slide.guide.assy.③.after.assembled.
Rod.adjusting.procedure
1. Insert slide guide assy ③ on rod support assy ① . Make it stand, as shown in the
drawing left down, and drop slide guide assy ③ in order to check if it comes down
smoothly.
(You may apply a slight coat of grease on the rod.)
If it drops smoothly, proceed to step 3 of the above Assembling Instruction.
If not, perform the following adjustments.
2. Check the rod from the top and twist it in every direction, then perform the above
step 1 for checking it again.
3. Place rod support ① on the controller cover shown in the drawing below, and level
two rods evenly. Perform the above step 1 for checking it again.
＊ Repeat.the.step.2.and.3,.if.needed..
【A-3】Rod Support
No.
Description
Description
Remarks
PN
1. Rod.Support.Assy.
Rod.support.assy
909556.
2. Push.Latch.
Push.latch
PR-4PK-B.
949861.
3. Slide.Guide.Assy.
Slide.guide.assy
See.A-2.
4. P.
Panel.spring.
949884.
