– 22 –
● .The.switch.panel.does.not.stay.in.place.even.if.pushed.in..Or.it.pops.out.with.every.
little.shock.
Possible.Cause.1.:..There.is.a.problem.with.adjustment.of.the.assembly..
Solution.1.:
Refer to to 〔3〕
【D】 “Adjusting the Controller”, and re-adjust the controller.
Possible.Cause.2.:..The.latch.is.broken..
Solution.1.:
Refer to〔6〕
【A】, and replace the latch.
【C】Problems with the Pedal
● The.pedal.does.not.work.for.the.electronic.sound.play..
Possible.Cause.1.:..A.connector.may.be.disconnected.
Solution.1.:
Check the connectors of sound source unit.
Solution.2.:
Referring to 〔6〕 【B】, open the sound source unit and check if all connectors
are firmly inserted.
Possible.Cause.2.:..The.position.adjustment.of.the.pedal.sensor.may.be.incorrect..
Solution.1.:
Refer to 〔3〕
【E】 “Adjusting the Pedal Sensor”, and adjust the sensor.
Possible.Cause.3.:..The.pedal.sensor.may.be.faulty.
Solution.1.:
Refer to 〔4〕
【B】, and check if the pedal sensor is working properly.
Solution.2.:
Replace the pedal sensor.
● The.pedal.effect.carries.on.for.electronic.sound.
Possible.Cause.1.:..The.position.adjustment.of.the.pedal.sensor.may.be.incorrect..
Solution.1.:
Refer to 〔3〕
【E】 “Adjusting the Pedal Sensor”, and adjust the sensor.
【D】Problems with emmitting Sounds
● No.acoustic.or.electronic.sound.comes.out.even.if.a.key.is.depressed..
Possible.Cause.1.:..Does.the.shank.stop.rail.stay.at.the.position.where.the.action.goes.in.and.out?.
Solution.1.:
Refer to 〔3〕
【A】, and set back the set lever.
Possible.Cause.2.:..If. the. demo. tune. is. playing. normally,. the. connector. of. the. hammer. sensor. might. be.
disconnected.
Solution.1.:
Check if the connector of the sensor is disconnected. The connector is located
inside the side board and at the side of the bass.
Solution.2.:
Referring to 〔6〕 【B】, open the connector cover of the sound source unit and
check if all connectors are firmly inserted.
Solution.3.:
Referring to 〔6〕 【B】, open the sound source unit and check if all connectors
are firmly inserted.
Solution.4.:
Check if one of the relay connectors inside the sound source unit is disconnected.
