16 / 44
Connecting the Turntable
Damage to cables from sharp edges and chafi ng points!
►
Do not lay cables across sharp edges.
►
Protect cables against possible chafi ng points.
Lay the master coaxial cable (marked red) to the control unit (CAP converter - “Antenna/IF Input“) and the slave coaxial
cable to a second TV with integrated SAT tuner or receiver (if available).
If you are not using a receiver, we recommend that you lay the second slave coaxial cable anyway, so that
you can use it later if necessary.
●
Lay the power supply cable of the turntable (3-pin plug) to the battery. Use the supplied power extension cable if
necessary.
●
Connect the master coaxial cable to the “Antenna/IF INPUT“ connector on the rear panel of the control unit (CAP
converter). Use the coaxial extension cable if necessary.
●
Make sure that all voltage feeds to the individual devices are protected with suitable fuses and have been professio-
nally installed. Make sure that all fuses are intact. If a fuse blows, the source of the fault must fi rst be eliminated. The
fuse may only be replaced by a fuse with the same rating.
Risk of severe injuries due to cable fi re!
►
Never bypass the fuse in the cable.
Mounting the LNB Arm Support
To ensure that the LNB arm is securely fi xed and that no vibrations can occur during travel, the LNB arm is seated on a
support.
1. Select a mounting location for the support (see distances in
Mounting the LNB arm support, p. 16
).
2. Mark the corner points of the support.
3. Apply sealing adhesive (e.g. DEKAsyl MS power adhesive) to both feet of the support and position the support
(proceed as described in:
Applying sealing adhesive and attaching the support, p. 40
)
337
127
56
●
At the connecting point for the power cable, the voltage must not fall below 11.5 V even with a higher load. Should
this nevertheless be the case, optimum functioning can no longer be guaranteed.
●
Only for motor homes:
The third, green core of the connecting cable, marked “ZÜNDUNG” (ignition), allows the
connection to a circuit in the vehicle that is activated when the ignition key is turned and then carries a continuous
12 V supply voltage. This connection ensures that the turntable is automatically lowered to the parking position when
the engine is started (the CAP converter does not have to be turned on for this).
●
Make sure that the 15 A fuse was expertly installed to the positive conductor (red) of the power supply cable.
Mounting the LNB arm support