42 / 44
Material damage due to impermissible tightening torque!
►
If the torque is too high, the thread in the mounting plate can be destroyed. If the torque is too low, the
screws can come loose due to vibrations
►
Observe tightening torque of 6 Nm!
13. Connecting the turntable to the vehicle electrical
system
– Red cable directly to the battery (12 V)
– Green cable to the ignition
– Black cable to the earth of the vehicle
14. Laying the coaxial cables
– Lay the master cable (red heat shrink tubing) to the
control unit
– Lay the slave cable to a second TV (if there is one)
Material damage to the device and malfunction due to reversing the polarity!
►
Mixing up the poles when connecting the power cables can lead to thermal overload and destruction of
components when starting up the turntable.
15. Determine the installation place for the control unit
– Clean the installation place
– Mark out the installation place
16. Attaching the control unit
– Use suitable screws
17. Connecting the control unit
– Master cable (red) to “Antenna” / “IF-Input”
– Connect TV to “TV/STB” / “IF Output”
– Connect pushbutton/control unit to the RJ12 socket
18. Connecting the control unit to the vehicle electrical
system
– Red cable directly to the battery (12 V)
– Black cable to the earth of the vehicle
Malfunction and material damage due to reversing the polarity!
►
Mixing up the poles when connecting the power cables can lead to thermal overload and destruction of
components when starting up the turntable.
19. Installing the parabolic refl ector
– Raise the turntable and stop it
– Install the refl ector using the enclosed screws
