13 / 44
Installing the Cable Gland Underneath the Turntable
If you have previously used a Kathrein HDM 140/141 jointed tripod mast or another mast with a diameter of
34 mm, you can continue using the existing through hole in the roof. There is no need to enlarge this hole,
as the roof gland also requires a borehole of 38 mm diameter.
O-ring
Adhesive
1. In the centre of the intended position of the turntable, drill the opening
for the cable gland with a circular drill of 38 mm diameter.
2. Deburr the hole using a round fi le or emery paper.
3. Insert the roof gland provisionally into the drill hole (see
Installing the
cable gland, p. 13
).
4. Continue with:
Installing the Mounting Plate, p. 13
.
Installing the Cable Gland Outside the Turntable
If a feed-through underneath the turntable, as described in
Installing the Cable Gland Underneath the Turn-
table, p. 13
, is not possible, you can use our external roof gland HDZ 100 to make an alternative feed-
through.
1. When installing the external roof gland, please observe the HDZ 100 instruction manual. It can be found under
https://www.kathrein-ds.com/support/downloadbereich
.
2. Continue with:
Installing the Mounting Plate, p. 13
.
Installing the Mounting Plate
The size of the holes and the choice of fastening screws to be used (not included) depend on the type and
thickness of the materials used in the roof structure. If the roof panelling (plastic roof) is strong enough, it is
recommended to use round head screws, plain washers and self-locking nuts to secure the mounting plate.
Arrow in the
direction of
travel
Adhesive area between the two grooves
Alternative roof fastening
Washer (not included)
1
2
3 *
)
*
)
*
)
*
)
1
2
3
Recess for cable
Adhesive area between
the two grooves
Installing the cable gland
Aligning the mounting plate
Fixing the mounting plate
Applying adhesive
