41 / 44
7. Align the mounting plate
– Arrow in the direction of travel
– Mark out and drill the holes for the mounting plate
8. Applying the sealing adhesive
– Apply the adhesive in wavy lines between the two
grooves
– Spread with a spatula or similar tool
Risk of skin injuries!
►
Avoid any skin contact with the sealing adhesive.
►
Observe the safety information of the adhesive.
9. Glue on and screw tight the mounting plate
– Place mounting plate on roof gland
– Fasten the mounting plate with suitable screws
10. Feed the cable of the turntable through the roof gland
(roof gland below the turntable)
Damage to cables due to sharp edges and chafi ng points!
►
Do not lay cables over sharp edges or bend them.
►
Secure cables against possible chafi ng.
11. Place the turntable on the mounting plate
– Continue to feed cables through the roof gland
– LNB arm must lie exactly on the support
12. Screw the turntable to the mounting plate using a
torque wrench
