32 / 44
Installing the CAP Converter on the Rear Panel of a TV Set
Danger to life due to high voltage!
Screws that are screwed in too deeply may damage the TV set beyond repair and cause danger to life
through electric shock.
►
Before starting any installation work, disconnect all units from the mains.
►
Before installing the CAP converter, check with the manufacturer of the device or in the documentation
supplied with it whether this is permissible, and if so, what aids (screws, etc.) are necessary or can be
used.
Material damage and risk of injuries due to overheating of the devices and fi re!
►
Do not install the CAP converter between a TV set and a wall bracket.
►
Only install the CAP converter on the rear panel of a TV set if the TV sits on a stand that is fi xed some-
where else.
Only two screws are required to secure the CAP converter to the rear panel of the TV set. Before installing the CAP
converter, note the following:
●
The TV set must have one of the following hole patterns for wall brackets on its rear panel: 100 x 100; 100 x 200; 200 x
200 or 200 x 400. If this is not the case, a VESA adaptor plate can be obtained from a specialist dealer.
●
Before mounting the CAP converter, read the chapter on wall mounting in the operating manual of your TV set to fi nd
out about the screw diameter (M4, M6 or M8) and the permitted screw-in depth.
Connecting the CAP Converter
The CAP converter may only be operated with a supply voltage of 10.5 - 30.0 V. The earth connection of the
CAP converter must be connected to the negative pole of the motor home or caravan battery. Disconnect
the vehicle electrical system (main switch “off “ or disconnect the positive pole from the vehicle electrical
system battery) before starting the following work.
●
Connect the master coaxial cable (coming from the turntable) to the F socket “IF Input“, on newer units “Antenna“, at
the rear of the CAP converter.
●
Connect the “IF Output“ socket, on newer units “TV/STB“, of the CAP converter and a receiver or TV set with integ-
rated tuner to a coaxial cable.
●
Connect the supplied power cable (depending on the power supply available in your motor home or caravan, 12 V or
230 V with mains adapter) to the “12 V 2.0 A“ plug-in connection of the CAP converter.
●
Check the connections before you reconnect the on-board power supply.
Connections on the CAP converter
RESET
TV/STB
ANTENNA
-
+
12V 2,0A
ETHERNET
STATUS
CONTROL UNIT
950-2150MHz
14/18V
400mA max.
22kHz
DE - 83022 Rosenheim
USB 2.0
5V 500mA max.
1
2
3
4
5
6
7 8
9
TV/STB
Output satellite signal to TV/receiver
ANTENNA
Input satellite signal from the turntable
RESET
Reset button
USB 2.0
Type A USB port
ETHERNET
Network socket, RJ 45
CONTROL UNIT
Connection for push-button/HDS 50/HDS 52, RJ 12
STATUS
Status LED to indicate the operating status
Power switch
12 V 2.0 A
Power supply
