Katadyn Spectra Catalina 340C, Installation And Operating Manual

Page: 62 / 83

62
Settings
Dealer Access Settings
It is highly recommended that users consult with a factory trained technician before altering any settings behind
the
‘ Dealer Access Point ’. Changing this settings without understanding the full effect of each change can void
the warranty of your system, and cause irreparable damage.
If any settings are inadvertently changed, they can be reverted back to the defaults by using the ‘ Factory Reset ’
feature.
Automatic PRV: Enables an optional Automatic Pressure Relief Valve, after it is installed. This setting should
remain off unless you are certain that you have this feature installed on your system.
Power Sensor: Enables or disables an optional power sensor, after it is installed.
PH/ORP: Enables an optional pH or ORP meter, after it is installed.
Z - Ion: Enables or Disables the optional Z - Ion system, after it is installed. If the Z - Ion is enabled, you should also
adjust the Flush Interval to 30 days.
Tank Level Monitors
Tank Setup - Enable/disable tank sensors.
Enable Tank Switch High - Enable/disable tank switch high. If this is disabled Auto Fill and Fill Tank
run modes will not be available.
Enable Tank Switch Low - Enable/disable tank switch low. If this is disabled Auto Fill mode will not
be available. Both High and Low tank switches must be enabled for Auto Fill mode.
Enable Tank Level 1 - Enable/disable tank level sensor 1. If this is disabled there will be no tank level
reading and tank level gauge will read “!”.
Enable Tank Level 2 - Enable/disable tank level sensor 2..