-
7
Adjust the air pressure reducer:
ATTENTION
Risk of damage due to acidic detergents.
Only use alkaline detergents for wheel
cleaning.
Note:
After performing the basic setup, the spray
pattern should only be changed by adjust-
ing the pressure reducer for air.
Wheel cleaner:
The uniform application onto the rims is fa-
cilitated if a suitable colouring agent is add-
ed to the rim cleaner concentrate.
1 Adjustment screw
Adjust the pressure of the micro emul-
sion as needed by turning the adjust-
ment screw.
The booster heater is supplied with partly
softened water with a water hardness of
7° dH.
For this purpose, the blending device mixes
fresh water and softened water.
1 Sampling tap
2 Outlet valve (to the booster heater)
3 Adjusting screw, fine adjustment
4 Adjusting screw, coarse adjustment
5 Inlet valve fresh water
Completely open outlet valve and inlet
valve.
Close both adjusting screws (turn in
clockwise direction).
Establish water inlet to the warm water
tank.
Open the sampling tap.
Slightly open adjusting screw coarse
adjustment.
Collect water from the sampling tap and
measure the water hardness.
Adjust the bypass valve until it is just
under 7° dH.
Set the water hardness to 7° dH using
the adjusting screw fine adjustment.
Close the sampling tap.
1 Key "1/ON"
2 Control lamp operating state
3 Display
4 LEFT key
5 RIGHT key
6 OK button
7 ESC button
1 Display
2 LEFT key
3 RIGHT key
4 OK button
5 ESC button
During normal operating mode, the control
panel display alternates between:
Day of the week, date, time, summer time
(Som)/winter time (Wint)
Operating time of the system on the current
day
Maintenance work due from customer ser-
vice (example).
If more than one maintenance procedure is
required, these will be shown in sequence.
If no maintenance procedures are required,
nothing will be shown.
Fault occurred (example).
If more than one fault is present, these will
be shown in sequence.
The number in parentheses shows the total
number of faults present.
If no faults are present, nothing will be
shown.
Note:
To acknowledge faults see "Troubleshoot-
ing"
Press OK button for more than 2 sec-
onds.
Press the RIGHT button.
Press the OK button.
The menu "customer settings" (see follow-
ing page) has been reached.
Basic setting air
Rim cleaner
Intensive foam
2.5...3.0 bar
3.0 bar
Micro emulsion (option)
Blending device (option)
Controls
SB MB standard
SB MB comfort
Normal operation
Open the menu "customer settings"
9
EN
Summary of Contents for SB MB
