-
33
1 Condensate drain valve
Hold the condensate drain valve over a
duct or a collection container.
Open the condensate drain valve and
drain the condensate.
Close the condensate drain valve.
1 Screw
2 Halves of the handle shell
3 Node piece
4 Needle bearing
5 O ring
6 Contact surface pipe/ handle shell
7 high pressure hose
Unscrew spray pipe.
Loosen 6 screws.
Remove the half of the handle shell.
Fill grease in the needle bearing cham-
ber in the handle shell.
Grease needle bearing and O-Ring.
Grease contact surface pipe/ handle
shell.
Screw back the two halves of the han-
dle shell.
1 Screw
2 Nozzle holder
3 Light sensor
4 Cover
5 Looking glass
6 Pressure plate
Loosen fuel pipe.
Pull out the light sensor sideways from
the holder.
Loosen 3 screws.
Remove the lid with the holder for light
sensor.
Remove the pressure plate from the
nozzle holder.
Clean the looking glass.
Assemble the parts in the reverse se-
quence.
1 Fuel pump
2 Filter casing
Lock the oil supply.
Unscrew the filter casing.
Clean filter with compressed air.
Assemble the parts in the reverse se-
quence.
Open the oil supply.
몇
WARNING
Risk of burns due to hot oil or hot parts of
the plant. Allow the pump to cool down for
minutes before oil change.
Note:
Used oil must only be disposed of by the
designated collection points. Please turn in
used oil there. Polluting the environment
with used oil is prosecutable.
1 Oil container lid
2 Oil drain screw
Keep a collection basin for old oil ready.
Remove the lid of the oil container.
Unscrew the oil drain screw and collect
used oil.
Insert washer and turn in the oil drain
screw.
Slowly fill in new oil until the "MAX"
marking on the oil container.
Close the oil container with the lid.
Deliver the old oil to the respective col-
lection centres.
Open the coin acceptor, and clean the
coin channel with a moist cloth and
washing liquid.
The correct setting of the ignition elec-
trodes is very important for the burner to
function properly. The settings have been
indicated in the above drawing.
Maintenance Works
Draining condensate at the compressor
Lubricate the hand-spray gun
Clean looking glass for flame
monitoring
Cleaning the fuel pump filter
Oil change
Clean the coin mechanism
Electrode setting
35
EN
Summary of Contents for SB MB
