Kalmar DRD450-80S4X, Maintenance Manual

Page: 92 / 600

UDRF01.04GB
Maintenance manual DRF 400–450
8 2 Transmission – 2.6 Lubrication
Oil filter transmission
5 Place a collection container under the oil filters.
6 Clean the area around the oil filters.
7 Remove the oil filters.
8 Install the new oil filters.
Wet the O-ring on the new oil filters with transmission oil. Tight-
en to contact and then another two-thirds of a turn.
9 When the transmission oil has drained, fit the drain plug.
Make sure that the washer for the oil plug is included.
Oil dipstick and filling point transmission oil
10 Remove the transmission dipstick and fill new transmission oil
through the dipstick's hole to the marking for low level on the
dipstick.
For volume and quality, see section F Technical data .
11 Start the engine and let the engine idle for at least two minutes.
12 Check that the drain plug for transmission oil seals tight.
13 Remove the collection container, handle the oil and oil filters as
environmentally hazardous waste.
14 Check the transmission oil level with the engine running at idle
and top up to the marking for low level.
Operating menu oil temperature
a. Transmission oil temperature
b. Hydraulic oil temperature
15 Warm up the transmission so that the oil temperature is 63-73
°
C. Use the operating menu to check the transmission oil tem-
perature.
16 Check the oil level and top up to the marking for max. oil level.
a
b
000356
https://www.forkliftpdfmanuals.com/