Kalmar DRD450-80S4X, Maintenance Manual

Page: 46 / 600

UDRF01.04GB
Maintenance manual DRF 400–450
14 C Preventive maintenance – Preventive maintenance
page –
Lubrication 500 hours
1 Clean the area around each grease cup before greasing.
2 Grease all points with lubrication grease, see section F Techni-
cal data .
Wheel hub and wheel spindle
Grease point wheel hub
3 Raise the right steering wheel with a jack (40 ton) so that wheel
bearings and wheel spindle are relieved of stress, do not lift to
a height where the wheel hangs freely.
4 Grease the wheel hub until grease comes out at the seal on the
hub's inside.
Lift the seal ring's lip with a small screwdriver to facilitate
pressing out of air. Grease until grease comes out by the seal.
NOTE
Work carefully so that the seal is not damaged.
Grease points wheel spindle
1. Upper grease point
2. Lower grease point
5 Grease the wheel spindle's upper and lower bearings.
NOTE
It is important that both upper and lower bearings are
greased separately since the grease is not pressed be-
tween the bearings.
6 Lower the wheel.
7 Repeat steps 3 - 7 for the left steering wheel.
https://www.forkliftpdfmanuals.com/