Kalmar DRD450-80S4X, Maintenance Manual

Page: 71 / 600

UDRF01.04GB
Maintenance manual DRF 400–450
1 Engine – 1.2.4 Fuel filter 13
page –
Fuel filter, changing (Cummins engine)
NOTE
Avoid skin contact with fuel, use gloves. Fuel on hands may
cause rashes and irritation.
Fuel filter, drain valve and connector for water in fuel
sensor
1 Machine in service position, see section B Safety .
2 Place a receptacle under the fuel filter.
3 Clean the area around the fuel filter.
4 Disconnect the wiring from the sensor for water in fuel.
5 Remove the fuel filter with filter tool.
6 Change the seal by the filter's threaded connection on the filter
holder and lubricate it with engine oil.
7 Fill the new fuel filter with pure fuel.
8 Lubricate the seal on the new fuel pre-filter with engine oil.
9 Fit the new fuel filter.
Tighten the fuel filter to contact and then another half to three-
quarter turn.
10 Turn on the main electrical power and start the engine. Check
that the fuel filter seals tight.
11 Turn off the engine and remove the receptacle. Handle the fuel
as environmentally hazardous and inflammable waste.
D A N GE R
Pay attention to the fire hazard when working on
the fuel system.
Avoid changing the fuel filter when the engine is
hot.
Fuel may spill on hot surfaces and may ignite.
https://www.forkliftpdfmanuals.com/