27
Step
Detailed Instructions
3.
Press then 30.
Before re-lock time expires, press (Enter key) followed by the 3 key and
then the 0 key. The lock re sponds with two beeps/flashes of the green LED.
4.
Enter Keypad User ID.
Enter a Keypad User ID to be deleted (or press the Enter key to exit.) The
lock re sponds with two beeps/flashes of the green LED if the User ID is
valid. The lock responds with two beeps/flashes of the red LED to indicate
an error.
5.
Enter Keypad User ID again.
Confirm the Keypad User’s ID by re-entering it. The lock re sponds with four
beeps/flashes of the green LED. The lock re sponds with two beeps/flashes
of the red LED if the User ID was un con firmed, if the User ID was not in use,
or if the User ID was not that of an Access User, Audit User, or Service
User.
The Keypad User is now deleted.
6.
Repeat Steps 4–5 to delete
If additional Keypad User IDs are to be deleted, repeat steps 4–5 until all
more User IDs or go to step 7.
User IDs have been deleted. If no additional User IDs are to be deleted, go
to step 7.
Caution: If you are deleting multiple Keypad User IDs, you may need to depress the outside lever to provide
additional power.
7.
Press .
Press (Enter key) to exit this procedure. The lock responds with two
si mul ta neous beeps/flashes of the green and red LEDs and exits this
procedure.
Delete Key Access User(s) Using the Keypad
Note: If at any time during the procedure the lock power drops below a sufficient level for operation, the lock will
continually beep and flash the red LED, prompting the user to depress the outside lever to provide additional power.
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User or a
Enter the Master User or a Manager User combination. The lock will beep/
Manager User combination.
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
fol lowed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the com bi na tion is not valid, the lock re sponds with
three beeps/flashes of the red LED.
3.
Press then 31.
Before re-lock time expires, press (Enter key) followed by the 3 key and
then the 1 key. The lock re sponds with two beeps/flashes of the green LED.
4.
Enter Key User ID.
Enter the four-digit User ID of the Key User to be deleted. The lock responds
with two beeps/flashes of the green LED if the User ID is valid. The lock
responds with two beeps/flashes of the red LED to indicate an error.
5.
Enter Key User ID again.
Enter the four-digit Key User ID for verification. The lock re sponds with four
beeps/flashes of the green LED. The lock responds with two beeps/flashes
of the red LED if the User ID was un con firmed or if the User ID was not in
use.
The Key Access User is now deleted.
6.
Repeat Steps 4–5 to delete
If additional Key Access Users are to be deleted, repeat steps 4-5 until all
Key Access Users or go to
User IDs have been deleted. If no ad di tion al Key Access Users are to be
step 7.
deleted, go to step 7.
Summary of Contents for PowerLever 455 Series
Page 1: ...PowerLever 455x Operating Instructions...
Page 37: ...37 Notes...
Page 38: ...38 Notes...
Page 39: ...39 Notes...
