24
Display Lock Enabled / Disabled Status
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User or a
Enter the Master User or a Manager User combination. The lock will beep/
Manager User combination.
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
fol lowed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the com bi na tion is not valid, the lock re sponds with
three beeps/flashes of the red LED.
3.
Press then 14.
Before re-lock time expires, press (Enter key) followed by the 1 key and
then the 4 key. The lock re sponds with two beeps/flashes of the green LED if
the lock is enabled, and with four beeps/flashes of the green LED if the lock
is disabled. Subsequently, the lock responds with two si mul ta neous
beeps/flashes of the green and red LEDs.
Enable a Keypad User
Note: This operation is used to enable lock access for either Keypad Access Users or Service Users.
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User or a
Enter the Master User or a Manager User combination. The lockwill beep/
Manager User combination.
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
fol lowed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the com bi na tion is not valid, the lock re sponds with
three beeps/flashes of the red LED.
3.
Press then 71.
Before re-lock time expires, press (Enter key) followed by the 7 key and
then the 1 key. The lock re sponds with two beeps/flashes of the green LED.
4.
Enter Keypad User ID.
Enter the User ID of the Keypad User to be enabled. The lockresponds with
two beeps/flashes of the green LED if the User ID is valid. The lock
responds with two beeps/flashes of the red LED to indicate an error.
5.
Enter Keypad User ID again.
Enter the Keypad User ID again for verification. The lock responds with four
beeps/flashes of the green LED. The lock responds with two beeps/flashes
of the red LED if the User ID was un con firmed, if the User ID was not in use,
or if the User ID was not that of an Access User.
The Keypad User is enabled.
6.
Repeat Steps 4–5 to enable
If additional Keypad Users are to be en abled, repeat steps 4-5 until all User
more Keypad Users or go to
IDs are enabled. If no ad di tion al User IDs are to be enabled, go to step 7.
step 7.
7.
Press .
Press (Enter key) to exit this procedure. The lock re sponds with two
si mul ta neous beeps/flashes of the green and red LEDs and exits this
procedure.
Summary of Contents for PowerLever 455 Series
Page 1: ...PowerLever 455x Operating Instructions...
Page 37: ...37 Notes...
Page 38: ...38 Notes...
Page 39: ...39 Notes...
