Juniper TCX1000-RDM20, Hardware Manual

Page: 81 / 206

Figure 21: Installing the TCX1000-RDM20 on a Two-Post Rack
7.
Turn over the rear brackets to mount the rear of the bracket upright. Continue to
support the chassis while sliding the rear brackets into the channel of the mounting
rails and securing the brackets to the rack. Use the four mounting screws (and cage
nuts and washers if your rack requires them) to attach each bracket to the rack. Tighten
the screws.
NOTE: Front-mount and rear- mount brackets can be as close as 3 inches.
(a minimum of 3 inches distance is required between the brackets).
8.
Ensure that the chassis is level by verifying that all the screws on the front of the rack
are aligned with the screws at the back of the rack.
9.
Install the fiber management clip on the front of the module, on the right or left hand
side, as required. See
Figure 22 on page 67 .
Figure 22: Installing the Fiber Management Clip on the TCX1000-RDM20
Related
Documentation
•
Mounting a TCX1000-RDM20 in a Rack or Cabinet on page 62
•
Connecting the TCX1000-RDM20 Grounding Cable on page 70
•
Connecting AC Power to a TCX1000-RDM20 on page 73
67 Copyright © 2019, Juniper Networks, Inc.
Chapter 11: Unpacking and Mounting the TCX1000-RDM20