Jungheinrich ESE 220, Operating Instructions Manual

Page: 101 / 170

Adapting the travel program configuration to the
user code
Procedure
• Press the O key (87).
• Enter the valid master code with the digit keys.
When you enter the valid master code the green
LED (86) flashes green.
• Enter the parameters 0-2-4 with the digit keys.
• Confirm with the SET key (85).
The LEDs (82,86) flash green.
• Enter the valid user code with the digit keys.
• Confirm with the SET key (85).
The LEDs (83,86) flash green.
• Enter the configuration code (4 digit) for the travel programs.
• Confirm with the SET key (85).
The LEDs (84,86) flash green.
• Enter the configuration code (4 digit) for the travel programs again using the digit
keys.
• Confirm with the SET key (85).
Wait until the LED (86) flashes green. The travel programs are now assigned to
the user code.
• Press the O key (87).
The truck is switched off and the LED (86) is lit red.
• Checking the travel program configuration to the user code:
• Switch on the truck with the configured user code, see page 86
After entering the valid user code the LED (86) lights up green, the travel
program setting is shown by the illumination of the corresponding LEDs
(82,83,84) and the truck is switched on.
• Press the O key (87).
The truck is switched off and the LED (86) is lit red.
• If necessary, repeat the procedure for other user codes.
85
82 83 84
87 86
101
04.19 en-GB