Jungheinrich EFG-Vac 22, Operating Instructions Manual, Page: 33 / 81

508
2973
- 501
1633
3 GB
D 6
6 Removing and installing the battery
m
The battery must not be lifted above the collision guard at the rear wall, otherwise the
ventilator or seat hood may be damaged.
– Exposing the battery
(refer to chapter D, Section 3).
– Pull out side wall (6, 7).
f
To prevent short-circuits, batteries with exposed poles or cell connectors must be
covered using a rubber mat. When changing batteries with the aid of a crane, ensure
that the crane is of adequate capacity (the battery weight is indicated on the battery
identification plate at the battery trough). The crane hoisting gear is routed through
the recess at the overhead guard and must exert vertical pulling action, so that the
battery trough is not crushed. The hooks must be fastened in such a way that they
cannot fall onto the battery cells when the crane hoisting gear is slackened.
– Attach the hoisting gear at the battery
trough.
– Lift the battery by means of the
hoisting gear to the right over the
frame and then swivel it outwards to
the side.
– Replacing the battery is done in reverse order.
f
When replacing the battery, make sure only to use the same type as replacement.
After reinstallation of the battery, visually check all cables and connectors for
damage. All covers and side doors must be securely closed.
f
During replacement/installation of the battery, pay attention that the battery is tight in
the battery box of the truck.
efg v d04 mitte
508
2973
- 501
1633
3 GB
D 6
6 Removing and installing the battery
m
The battery must not be lifted above the collision guard at the rear wall, otherwise the
ventilator or seat hood may be damaged.
– Exposing the battery
(refer to chapter D, Section 3).
– Pull out side wall (6, 7).
f
To prevent short-circuits, batteries with exposed poles or cell connectors must be
covered using a rubber mat. When changing batteries with the aid of a crane, ensure
that the crane is of adequate capacity (the battery weight is indicated on the battery
identification plate at the battery trough). The crane hoisting gear is routed through
the recess at the overhead guard and must exert vertical pulling action, so that the
battery trough is not crushed. The hooks must be fastened in such a way that they
cannot fall onto the battery cells when the crane hoisting gear is slackened.
– Attach the hoisting gear at the battery
trough.
– Lift the battery by means of the
hoisting gear to the right over the
frame and then swivel it outwards to
the side.
– Replacing the battery is done in reverse order.
f
When replacing the battery, make sure only to use the same type as replacement.
After reinstallation of the battery, visually check all cables and connectors for
damage. All covers and side doors must be securely closed.
f
During replacement/installation of the battery, pay attention that the battery is tight in
the battery box of the truck.
efg v d04 mitte