Operation manual
Ⅰ
3
−
1
Chapter
3
Various
processing during production
This Chapter describes how to handle main errors that will occur during PWB production
and a component run-out error.
3.1 When components run out
(If the check box “Stop system when
components run out” is checked on the “Operation option” screen)
Immediately after components run out, the following screen appears and the machine
stops temporarily.
Error screen
Causes of the error
①
The stocked components run out.
②
The machine failed to pick up a
component.
(Due to jammed peel-off tape or a
pick-up position error caused by
defective tape feeding)
How to handle an error
When you press the <CAMERA> button of the HOD while the machine stops because
components run out, you can recheck the pick-up position where a component run-out
error occurred. If a component pick-up error is serious, perform a teaching operation
again.
After replenishing the machine with
components or removing the cause of
a component run-out error (such as
jamming of tape), select the <Retry>
button, and then press the <START>
switch.
This button makes the machine skip
the placement position at which
components run out to pick up the next
component to be placed.
Use this button when you do not have
components at hand.
Immediately after the machine finishes
placing the components that can be
placed on boards, it pauses again.
