21
© 2017 JTECH Medical MN022_M
Introduction to Dual Inclinometers
The Echo Inclinometers were designed to make measuring spine and large extremity ranges of motion faster,
easier and more accurate. Using Dual Inclinometers fulfills the requirement to capture the compound motion
of the spine by measuring two points concurrently. Our Dual Inclinometers can be used to measure extremities
using either single or dual inclinometry.
Features
•
Eliminates calculation, placement changes, and repeat procedures.
•
Provides recording of the Total Range of Motion, Upper Segment Extreme and Lower Segment Extreme for
spine range of motion measurements (vital data for AMA-based impairment rating).
•
Records up to eight repetitions per test, for up to 20 tests.
•
Features Dynamic, Static, and Auto-rep testing modes for the spine and extremities.
•
In Auto-rep testing mode, the Console automatically records movement end-points so testing is more
convenient.
•
Measure extremities with either dual or single inclinometry.
•
Capable of simulated goniometry.
General Inclinometry Testing
Prior to beginning a test, ensure that the test defaults are set as desired (i.e. unit of measurement, number of
tests, number of repetitions, etc.). Once test defaults are set, choose the “Test” option from the main menu,
and follow these steps:
1 .
Select “Inclinometer” from the Test menu (Note: if you have purchased a new inclinometer and it is not on
the list, see page 18 for instructions or contact customer service to register your new inclinometer).
2 .
Upon selection, the Commander Echo Console will attempt to connect with the Primary Inclinometer.
3 .
Press the “On/Enter” button for the Primary Inclinometer to establish a connection with the Commander
Echo Console.
4 .
After successful connection to the Primary Inclinometer, the Console will as if you want to “Connect to
Secondary Device?” Select “Yes” or “No.”
i .
If you select “Yes”, Press the “On” button for the Secondary Inclinometer to establish a connection with
the Commander Echo Console.
5 .
The Commander Echo will automatically advance to the next available test in the series. If no test data is
currently being stored for the instrument, it will begin with Test 1. If all of the selected tests already have
data stored, then the Commander Echo Console will display Message 2 on the LCD and not allow further
testing until the data has been erased, or the test settings have been altered to allow for more tests.
6 .
Ready the patient and begin the test (Note: see the optional Multimedia Help System CD for further
information on specific testing procedures).
7 .
Once you have completed the pre-set number of repetitions for each side/test, the Commander Echo will
automatically advance to the next test in the exam.
8 .
Once all tests have been completed, the Commander Echo Console will display Message 2 on the LCD to
notify you that there are no more empty tests available. Pressing the Control Stick will bring you back to the
main menu
Note: The Commander Echo Console does not require a zero calibration of the Inclinometers prior to starting
each exam.
