8
XP70 Instruction Manual
The XP70 offers a programmable Trainer function that
allows the transmitter to operate in three different Trainer
modes.
Normal:
The transmitter can be used as a master or slave but the
slave transmitter must have the same programming (i.e.
reverse, travel adjust, dual rates, mixes sub trims, etc.) as
the master.
P-Link:
Pilot Link is where the master transmitter maintains control
of all primary and secondary functions (i.e. Dual Rate,
Expo, Gear, Flaps, etc.) and only the primary stick controls
(aileron, elevator, rudder and throttle) are transferred to the
slave transmitter.
NOTE
: If the slave transmitter is a normal transmitter
or if another JR radio is used in normal TRAINER
mode (not in a P-LINK/Slave mode), all programming
functions must match the master transmitter.
Slave/P-link:
In the Slave mode, the XP70 is used as a slave radio in
conjunction with a JR radio that is used as the master that
is in P-LINK mode; there is no need to match the slave’s
programming to the master transmitter’s programming.
Trainer
To Enter the Trainer Mode
[TRAINER]
≥NORMAL
SW:L-ROCKER
Press to enter main screen
Press to enter TRAINER FUNCTION
Press to select trainer type
Press the
Down
and
Select
keys simultaneously then
turn on the transmitter.
Press the
UP
key until
TRAINER FUNCTION
appears
on screen.
Press the
IncreaSe
or
DecreaSe
key to select
the desired Trainer type:
INH
,
NORMAL
,
P-LINK
or
SLAVE/P-LINK
. Also note that the trainer switch can be
located on the right or left rocker switch. Use the
Select
key to highlight
SW:R
then press the
IncreaSe
or
DecreaSe
key to select the right (
R
) or left (
L
) rocker.
