JR ProPo xg8, Operation Manual

Page: 9 / 92

8
Before charging the battery, be certain to read the precautions written on the battery surface sticker.
The transmitter operates exclusively with genuine JR Li-fe batteries. Do not use the transmitter with other recharge-
able batteries or with dry cell batteries.
During charging, the transmitter should be switched off. When the transmitter is in the ON condition, charging will
not take place.
On the other hand, if the cord is inserted in the Trainer Jack in the condition where the power switch is in the OFF
condition, it will be possible to enjoy using the transmitter as a flight simulator using the AC adaptor electric power.
Since the built-in battery will not be used, this will allow enjoyment while conserving energy.
Methods of Mounting and Removing Batteries
While pressing the triangle mark on the rear surface battery lid, slide the lid in the arrowed direction and remove the battery cover.
Insert the rechargeable battery connector into the transmitter battery connector.
Insert the rechargeable battery into the battery box, and mount the battery cover, taking care not to pinch the lead wires.
Insert the AC adaptor into the AC electric power socket.
Connect the plug of the AC adaptor as far as it will go into the DC power jack of the transmitter.
During charging, the transmitter LED will light in a reddish purple color. When charging has been
completed, the LED will switch off.
The standard charging time is approximately 3 hours.
After the charging has been completed, quickly detach all of the connections.
Absolutely do not leave the battery connected as it is to the power source.
In the situation where the transmitter LED does not light, an error will have occurred.
In this situation, detach the AC adapter plug once, then re-insert it.
In the case where the LED does not light even after the cable has been inserted and removed several times, please
contact this companyʼs Service Section.
* Be certain to use the genuine JR XG8 dedicated AC adapter (NEC-A912).
Normal charging cannot be carried out using other AC adapters. Further, do
not use this AC adapter for charging other products.
Do not use the AC adapter cord while the cord is
still bundled together, since there will be a risk of
heat generation.
Method of Charging the Transmitter Battery
Preparation
To the AC Electric Power Outle
To the Recharging Power Source Jack
(Exclusively for transmitters with
built-in Li-fe rechargeable batteries)
When removing the connector, press
the lever part to release the lock while
pulling out the connector.
Caution
Caution
※※※※ ※※※※ ※※※※ ※※※※ ※※※※
Battery Connector
Battery Box
Battery Cover
Power source jack
for recharging (DC9V)
1
2
3
1
2
3
4
※
9V12W AC Adaptor for
Recharging (NEC-A912)
* Caution: This is not a
battery charger.