20
SERVO SPEED
Each Function in the Function List
Function Explanation
This function slows down the operation speed of the servos of each channel. For operations at speeds slower
than the set speed, the function will not operate.
This function should be considered as a speed limiter. The speed setting can be set separately to the left and
right (up and down) from the neutral position. Additionally, the setting can be set to ON/OFF in each Flight Mode
or using optional switches. Further, this function is similar to the Stick Position switch, and ON/OFF can be carried
out using a desired throttle stick position (except in the case of gliders).
* The screen channel names will be different for each model type.
•
Setting Method
The setting screen has three pages. In Pages 1 and 2, the speed settings in each of the channel directions are
carried out, while Page 3 is the setting screen for the operation switches. Rotate the dial to move the inverse
display area and select the channel, then press the dial to display the setting box, and carry out the speed setting.
“NORM” is the fastest setting, and the speed can be slowed between 0.1-15.0 seconds. This indicates the time
that the servo takes to rotate through 60 degrees. However, there may be some slight differences depending on
the servo.
This allows selection of the switches that this function switches ON/OFF. The ON/OFF operation condition
is displayed on the screen.
•
●
Page 3 Screen
【
SRV. SPEED
】
・Depending on the application, channels having invalid servo speeds will be displayed as “----” and will
not be possible to set.
・The setting values can be reset by pressing the CLR key.
・Because position inputting will also be carried out in this Switch Selecting screen, automatic setting
using switch operation will not apply.
Hints
When the switches have been set, carefully confirm the servo speeds using actual switch operation.
Caution Ite
Helicopter
Airplane
Glider
●
Page 1 and 2 Screens
The screens show the displays for helicopter models.
Speed in Each Direction
This selects the Channel
Directions in which the Speed
is to be Controlled
This will become ON at values
below the set value.
Clicking the □ mark will change it to the
■ mark and set it to ON.
ON/OFF Function using the Throttle Stick
(Helicopter and airplane types only)
To the Switch
Selection Screen
Summary of Contents for xg8
Page 77: ...76 MEMO...
Page 90: ...89 MEMO...
