43
BRAKE SYSTEM
Each Function in the Function List
Function Explanation
This function recreates air brakes using the spoilers, ailerons, and flaps. The function is also known as
Butterfly mixing and Crow mixing. When the spoiler stick is lowered, the flaps will lower and the
ailerons will be lifted, so that looking from the front of the aircraft this will appear as air brakes. A
blind band can be set to prevent mis-operation when operating the spoiler stick. In addition, the
correction provided to the elevators can also be given detailed settings corresponding to the air
brake angle using the curve points.
•
•
Setting Method
•
•
【BRAKE SYS.】
When this function is fully operated, the servos will move by a considerable amount. At this time,
care will be required to avoid applying an unreasonable force to each of the control surfaces. Use
the Limit Adjust function to apply limits to the servo movements to avoid damaging the control
surfaces.
After making the settings, operate the servos and carefully confirm each of the Flight Mode
settings before flying.
Cautions
•
•
First set the mixing amount provided from the Spoiler Stick operation to the ailerons and flaps.
Then adjust the Stick position where this mixing will be started.
This selects the switch for switching
ON/OFF the function.
●
Page 1
●
Page 2
●
Page 3
This shows the movement angle when the
spoilers are incorporated.
Initially, curve setting points will
not be set. To add points, set the
stick to the position that you wish
to add the point, and press the
“ADD” key.
In the situation of deleting this
point, this should be carried out
using the “DEL” key.
The figure shows the situation
where two points have been
added.
Points that can be adjusted using the Trim Input on the multi-curve screen are shown by circles.
Glider
This adjusts the
stick position where
the brake operation
will be started.
The Trim Input switch can be used.
Trim Input Switch Setting Screen
Trim Input Switch Selection
These are the
movement angles to
the ailerons and flaps.
・FPRN:
Ailerons
・FLAP:
Flaps
This sets the correction mixing to the elevators.
This changes the Point
Connections to a Curve
Point Addition
and Deletion
Adjustment Point Display
Numerical Display of Stick Input
Position and Output Position
Input Position and
Output Position of
Each Adjustment
Point
Summary of Contents for xg8
Page 77: ...76 MEMO...
Page 90: ...89 MEMO...
