21
THROTTLE CURVE
Function Common to All Models
Function Explanation
This function adjusts the servo operation in response to the throttle stick operation. The stick operations can
be set to servo positions corresponding to a maximum of 5 point positions. In addition, an EXPO (exponential)
function is also incorporated to allow smooth connection of each of the points. This curve setting allows
setting of a maximum of 5 models in each Flight Mode for helicopters, and one model for airplanes.
•
Setting of Each Item
•
Setting Method
The initial curve setting
points are three points set to
the slow, center, and high
sides. To add a point, set the
stick to the desired position
and press the “ADD” key.
In the situation where the
point is to be deleted, this
should be carried out using
the “DEL” key. The figure
shows the situation where
the number of points has
been increased to 5.
When switching to this screen, for safety reasons you will be asked whether all servos should be fixed. After confirming this,
the screen will change to the Setting screen. In the situation where the servos have been fixed, in order to exit from the
Adjusting screen the throttle stick should be set to the slow side, and in the case of helicopters it will also be necessary to set
the Flight Mode to “NORM”.
•
The setting values in this function are all between 0 and 100.
The input positions (IN) can also be adjusted using the dial. In addition, when inputting the points of the
output positions (OUT), it will be possible to select and adjust the points using the throttle stick.
If the engine and motor torque band are set so that they can be effectively utilized, the handling will
become simple.
The screen display contents will differ slightly according to the model type.
•
•
•
•
Even if the Hovering Throttle Trim is operated, affecting the graph, each of the point output
numerical values will not change. The numerical values below the graph will be influenced by
the operation.
Actually operate the servos and carefully confirm the settings before flying.
•
•
Caution Items
Hints
Caution
Dial
Rotate the dial to move to and select the item (inverse display).
Then press the dial to display the setting box, and carry out the
numerical value setting.
The setting condition can be confirmed using the graph on the screen.
•
In the airplane (ACRO) models, it will be possible to select the
switches that switch ON/OFF this function. Rotate the dial until
“SW SEL” is displayed, then press the dial and select the switch
from the Switch Selecting screen.
•
Selecting the Switches that Switch
ON/OFF the Function
Click on each □ mark to change it to ■
and set it to ON. If “AND” is clicked, only
one location will be set to ON inside each
switch position.
【THRO CURVE】
Helicopter
Airplane
Adjusting Point
Display
This changes the Point
Connections to a Curve
Numerical Display of the Stick Input
Position and Output Position
Current Flight
Mode Position
Each Adjusting Point Input
Position and Output Position
Point Addition
and Deletion
Caution
：
The graph may be
changed by the
Hovering Throttle
and the Throttle
Trim.
Example of
Settings Box
This copies the Curve
Summary of Contents for xg8
Page 77: ...76 MEMO...
Page 90: ...89 MEMO...
