JR ProPo XG6, Operation Manual

Page: 9 / 84

7
▋
Notes▋on▋stick▋tension▋spring▋adjustment▋and▋
thethrottle▋stroke▋travel▋adjustment▋plate
▋
▋
This▋allows▋adjustment▋of▋the▋
stick▋spring▋strength.
① Be certain to remove the battery before carrying
out any adjustments.
② Remove the screws in the eight (8) locations on
the rear case.
③ Adjust the springs to the desired spring tension.
By carefully adjusting each of the screws, you
can achieve a range of spring tensions.
④ Close the rear cover, and tighten the screws.
Take care of interlocking of the levers, etc.
If you prefer a ratchet on the throttle, replace
the spring plate as shown in the drawing on the
left at the bottom of this page.
※ The drawing on the right shows the default
setting, giving a smooth throttle transition.
Never Touch the Printed Circuit Board or any
related parts inside the transmitter.
Screws x 8
For the Throttle
※ STICK TYPE MODE 1
For the Aileron
For the Elevator
For the Rudder
※ Touching the board may result in electric shock, uncontrolled microcomputer operation, or
damage to model data, and normal operation may become impossible.
Detail of this area.
Screw to secure spring
Screw for spring adjustment
Screw to secure spring
Screw for spring adjustment
Direction of the
Ratchet spring
Direction of the
Ratchet spring
Contact Surface
Out Out
For Airplane For Helicopter
※Ratchet operation ※Smooth operation
Direction of the
Ratchet spring
Direction of the
Ratchet spring
Contact Surface
Preparation
XG6.indd 7 12/03/01 16:03