JR ProPo XG6, Operation Manual

Page: 60 / 84

58
▋ Telemetry▋System【TELEMETRY】
▋
▋
Function▋Explanation
This allows confirmation of the telemetry sensors present in a particular aircraft, gathering
information such as Receiver Voltage, Altitude, Temperature or Propeller or rotor blade r.p.m.,
etc. In addition to the data on the display, alarms are used, so as aircraft conditions can be
monitored without taking your eyes off the aircraft.
▋
▋
Setting▋Method
▋ ▋ Receiver▋battery▋(RX-BATT)▋
No▋Link▋Alarm▋(NO▋LINK▋ALARM)
⿟ Receiver Battery Alarm
This function alerts to a drop in receiver battery voltage. Initially
it is inhibited.
To activate, set the alarm Voltage between 3.0V ‒9.0V in 0.1V
increments.
⿟ No Link Alarm
This will warn when the transmitter is no longer receiving data
from the model. Initially it is set as inhibited. Set the delay after which the alarm should sound to either 10S (10
seconds), 15S (15 seconds), 20S (20 seconds), or 30s (30 seconds).
▋ ▋ Temperature▋(TEMPERATURE)
⿟ Units (SCALE)
This selects the units for temperature display - Celcius ( °C) or
Fahrenheit (°F). Select the units as desired.
⿟ Alarm (ALARM)
This sets the temperature at which the alarm will sound ‒
between 30 and 500 °C. Initially this alarm is inhibited. Set the
temperature to the desired alarm point.
▋ ▋ Revolutions▋Per▋Minute▋(RPM)
⿟ Gear Ratio (GEAR RATIO)
It is possible to monitor the Helicopter's actual rotor blade
r.p.m. by entering the gear ratio. Check the gear ratio for each
Helicopter by checking your manual. Initially it is set as inhibited.
Set the necessary numerical value. Gear Ratios can be set between
1.00 ~20.00 in 0.01 increments.
⿟ Number of Blades (PROPELLER)
It is possible to monitor an Airplane's actual Propeller r.p.m by
installation of an optical sensor. It is necessary to input the number of blades of the propeller in order to have
actual Propeller r.p.m displayed. Initially, it is inhibited. The number of Propeller blades can be set between 1-20.
⿟ Delay (DELAY)
It is possible to display and store the maximum r.p.m. recorded in each flight mode. However, when the flight
mode is changed, the sensor may immediately store a maximum value, which would be invalid. To avoid storing
incorrect r.p.m. data, this function allows rpm to stabilize before storing any data. Initially it is set to inhibited. Set
the desired numerical amount which would suit with your model. The delay can be set from 0.5s (0.5 seconds) ~
10.0s (10 seconds) in 0.5 seconds increments.
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
System▋List
XG6.indd 58 12/03/01 16:04