joule HHH-AEHP-00001, Installation & Maintenance Manual

Page: 69 / 116

69
Modul-AIR Exhaust Air Heat Pump Installation Guide
Preface
Sequence of commissioning
Commissioning the Modul-AIR Unit
To be able to commission the Modul-AIR system correctly specific knowledge is required. If you are not
certified by Joule, you may not put the Modul-AIR into operation. To be certified by Joule the installer must
have successfully completed the Joule Modul-AIR training course. If you do not meet these requirements,
please contact Joule directly to enquire about booking a place in one of our training sessions. The installer
of the Modul-AIR system does not need to be in possession of a STEK or F-gas approval to be able to install
the Modul-AIR system.
Before the Modul-AIR Unit can be commissioned both the full mechanical system installation and full
electrical wiring procedure must be entirely complete. Before you start the commissioning procedure make
sure you have received and read all the provided information sheets. The data in the info sheets is necessary
to know in order to install the Modul-AIR successfully.
When commissioning the Modul-AIR follow the work sequence below for best practice:
1. Check whether the air ducts are clean and that there are no blockages.
2. Properly adjusted the ventilation rates as per Joules specific design rates for your installation.
3. Set the Modul-AIR units general settings as per this manual.
4. Ensure the Central Heating & DHW systems are correctly balanced.
5. Set the individual radiators heating controls if any.
6. Ensure the OT Room thermostat is connected and correctly calibrated.
7. Ensure the RF receiver is connected and properly communicating with the sensors (if present)
8. Set the DHW tank settings on the Modul-AIR display (All-E and Aqua)
9. Commission the Green Comfort Module (if present).
10. Handover the Modul-AIR to the end user.