25
139760_A GF 500 DV Oct. 2017
Log Set Installation
The GF 500 DV log set must be installed before
operating the burner. The log set includes six log pieces,
packaged inside the firebox. Place the logs on the burner
in order as numbered in figs. 46-47. Mate holes in the
underside of logs with pins or nubs on the adjoining
parts.
#157706 Log Set Identification
Install the logs in this order:
#1 Rear Log
#2 Lower Left Log
#3 Lower Right Log
#4 Upper Left Log
#5 Upper Right Log
#6 Small Front Log
Figure 46. Set the Upper Left, Upper Right, Front logs into
place.
Figure 48.
Use caution in placing the logs to ensure that
the pilot carry-over ports are not obstructed.
Figure 47. Set the Rear, Lower Left, and Lower Right logs
onto the burner base as shown.
1
2
3
4
5
6
A quantity of ember stones is included with the
log set.
THE EMBERS ARE ONLY INTENDED TO BE USED
AS FILLER ON THE STEEL SHELVES AT EACH SIDE OF
THE BURNER IF THE OPTIONAL BRICK PANELS ARE NOT
INSTALLED. DO NOT PLACE EMBERS ON THE BURNER BASE
ITSELF.
A quantity of rock wool is included as an
enhancement to replicate glowing embers. Use a
toothbrush or tweezers to
sparingly
place pinches of rock
wool on the front of the burner base.
DO NOT PLACE ROCK WOOL OVER BURNER PORTS.
DO NOT USE THE ENTIRE QUANTITY OF ROCK WOOL.
BE SURE TO KEEP THE PILOT CARRY-OVER PORTS CLEAR OF
OBSTRUCTIONS. SEE FIG. 47.
WEAR GLOVES AND HANDLE THE LOG PARTS CAREFULLY.
1
2
3
4
5
6
