7
Operation
Electrical movement of the landing gear in momentary-contact
mode
Activate the system by pressing both control elements (1)
simultaneously for two seconds. Both control elements flash
at the same time when the control unit is activated.
Select the travel direction by pressing a control element in
the required travel direction, and hold the control element
pressed until the required landing gear position has been
reached (min. 3 seconds).
The motor stops as soon as the button (1) is released or when
the maximum permitted motor current is exceeded.
The control unit switches itself off automatically after ten seconds
when the travel procedure has finished in automatic or momen-
tary-contact mode.
ADVICE!
If no travel direction selection is detected by the
control unit within ten seconds of it being acti-
vated, the electric drive switches itself off automat-
ically.
If the permitted motor current of the electric
drive is exceeded and the landing gear has not yet
reached the required position then the system
must be restarted or the landing gear moved to the
required position manually using the crank. This sit-
uation can arise if:
The outside temperature is too low so that the
available current is inadequate.
The landing gear cannot move freely due to
wear or damage.
28
MUB 006 001 M01
(REV-D)
07-2020
Modul E-Drive
