Johnson Controls FMS-1655 Series, Installation Manual, Page: 13 / 70

Due to continuous improvement, TRIATEK reserves the right to change product specifications without notice.
SUBHEAD
FMS-1655 Flush-Mount with Internal Sensor
- 6 -
6. Terminate all electrical connections at the
backplane taking note of the terminal labels.
Note that the power connector is distinguished
as it is of a different color and separated
from the other connectors. The 45-degree
positioned wire openings on the connectors
should greatly facilitate the wire termination
process.
7. On the opposite side of the wall, a length
of pressure tubing will be protruding from
the wall. Cut the tubing as needed to leave
approximately two inches protruding. Press
the tubing onto the barbed fitting of the flow
tube mounting plate (see page 10). Push
the mounting plate and tube toward the
wall, forcing the excess into the wall space.
Fasten the mounting plate to the wall using
appropriate hardware.
8. Mount the louvered stainless steel cover
plate to the mounting plate with the screws
supplied.
9. Apply power to the FMS-1655 and confirm
that following a brief initialization sequence,
the unit displays the room differential pressure
and the Safety Halo™ status matches that of
the main display screen. FMS-1655 units are
shipped from the factory in neutral isolation
mode.
MOUNTING/WIRING