SECTION 6 - JLG CONTROL SYSTEM
3121714
6-47
Table 6-11. System Test Messages
Message Displayed on
Analyzer
Message Displayed on
Analyzer
Description
RUNNING
Initial display when system test is run while running certain “critical” checks are made.
CHECK GROUND/ PLATFORM SELECT
The analyzer must be connected to the active control station to run the system test
CHECK CAN WIRING
The system test cannot run unless the CAN Bus is operating properly
BATTERY VOLTAGE TOO LOW
The system test cannot run with MTM-reported battery voltage below 39.5V (not UGM-compen-
sated value)
BATTERY VOLTAGE TOO HIGH
The system test cannot run with the MTM-reported battery voltage above 65V
CHECK SPEED
Reported vehicle speed must = 0 Hz (or mph)
HIGH TILT ANGLE
The vehicle is tilted > 3° or the tilt sensor if faulty
OPEN FOOTSWITCH
In platform mode, the footswitch must be open at the start of the test.
CLOSE FOOTSWITCH
In platform mode, the operator must close the footswitch when this message is displayed
BAD FOOTSWITCH
The two footswitch signals are not changing together, probably because one is open circuit. Check
footswitch and wiring.
OPEN FOOTSWITCH
In platform mode, the operator must open the footswitch when this message is displayed.
PLATFORM OVERLOADED
Load Sensing is configured and the ground module considers the platform to be overloaded
TESTING VALVES
CLOSE FOOTSWITCH
*Check for Footswitch closed
OPEN FOOTSWITCH
*Wait for Footswitch to open
PRESS AND HOLD FOOTSWITCH
*The operator must engage and hold the footswitch for the next batch of tests to be successful.
This is due to the hardware high side driver cutout in the ground module
LIFT BYPASS VALVE (E400
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
OPEN FOOTSWITCH
*Wait for Footswitch to open the advance
FLOW CTRL VALVE
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
PRIORITY BYPASS (E400)
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
STEER RIGHT
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay
STEER LEFT
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
SWING LEFT
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
SWING RIGHT
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
SWING ASSIST VALVE (E400)
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
LIFT UP
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
LIFT DOWN
SHORT TO BATTERY or OPEN-CIRCUIT; or SHORT TO GROUND (or advance test after short delay) do
not energize for E300
TELESCOPE OUT
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
TELESCOPE IN
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
TOWER UP (E300, E400)
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
TOWER DOWN (E300, E400)
SHORT TO BATTERY or OPEN-CIRCUIT; or SHORT TO GROUND (or advance test after short delay). do
not energize for E300
JIB UP
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
JIB DOWN
SHORT TO BATTERY or OPEN-CIRCUIT (or advance test after short delay)
JIB LT VALVE
SHORT TO BATTERY or OPEN-CIRCUIT (or advance test after short delay)
JIB RT VALVE
SHORT TO BATTERY or OPEN-CIRCUIT (or advance test after short delay)
PLATFORM LT VALVE
SHORT TO BATTERY or OPEN-CIRCUIT or SHORT TO GROUND (or advance test after short delay)
Summary of Contents for E450A
