JLG E450A, Service And Maintenance Manual, Page: 357 / 480

SECTION 6 - JLG CONTROL SYSTEM
3121714 6-41
PLAT LVL DEMAND UP/DOWN XXX%/CREEP Direction and percentage of input command (or CREEP if applicable)
from Function Speed Pot or Ground%
PLAT LVL OUTPUT UP/DOWN XXX% Direction/state of Level directional valve
PLAT ROT DEMAND LEFT/RIGHT XXX%/CREEP Direction and percentage of input command (or CREEP if applicable)
from Function Speed Pot or Ground%
PLAT ROT OUTPUT LEFT/RIGHT XXX% Direction/state of Rotate directional valve
PUMP SPEED CMD XXX% UGM pump command value: 0-100%
PUMP SPEED FDBK XXX% Pump PWM reported from MTM
PUMP CURRENT FDBK: XXXA Pump current reported from MTM
PUMP ENABL ON/OFF UGM pump enable bit status
PUMP OP MODE OFF/RUNNING Pump status from MTM
FUNCTION SPEED
[Platform Mode = True]
SETTING: XXX% Displays the percentage demand from the Function Speed
Potentiometer.
CREEP SW
[Platform Mode = True]
OPEN/CLOSED Status of Creep Switch Input
CREEP MODE ON/OFF Displays status of Creep Mode
FLOW CONTRL VLV XXX% Duty cycle of flow control proportional valve
SYSTEM MAIN CONTACTOR ENABLED/DISABLED Status of Main Contactor reported by Zapi module
MAIN CONT VOTE ENABLED/DISABLED Status of Main Contactor voting relay by UGM
CHASSIS TILT XX.XDEG Combined X/Y Absolute Angle
CHASSIS TILT X-AXIS: XX.XDEG X Angle with respect to sign
CHASSIS TILT Y-AXIS: XX.XDEG Y Angle with respect to sign
UGM AMBIENT TEMP XXXC/XXXF Ambient Temperature Sensor Reading from on-board UGM Sensor
LOW AMBIENT TEMP XXXC/XXXF Low Temp Cutout Sensor Ambient Temperature sensor Reading
[MACHINE SETUP ' TEMP CUTOUT = YES
LOW TEMPERATURE CUTOUT: ACTIVE/INACTIVE/FAULTY Status of Low Temperature Cutout; Only displayed if
MACHINE SETUP

TEMP CUTOUT = YES
MSSO ACTIVE/INACTIVE Status of MSSO
[MACHINE SETUP'MARKET=CE and Operating Mode=Ground]
Table 6-9. DIAGNOSTICS - Menu Descriptions
Diagnostics Submenu
(Displayed on Analyzer
1
st
Line)
Parameter
(Displayed on
Analyzer 1
st
Line)
Parameter Value
(Displayed on
Analyzer 2
nd
Line)
Description