JLG 530LRT, Service And Maintenance Manual

Page: 217 / 262

SECTION 5 - JLG CONTROL SYSTEM
3121781 5-21
Oscillating Axle Tilt Sensor
(Item 4, Figure 5-8.)
1. Place machine on level surface
2. Start with machine in the stow position
3. Go to CALIBRATIONS > AXLE TILT
4. Select Enter
5. Analyzer says "Level Vehicle"
6. Select Enter
7. Analyzer will display the Axle Tilt Calibration Values
8. Hit Escape to leave menu.
Set Stow Elevation
1. Place machine on level surface
2. Start with machine in the stow position
3. Go to CALIBRATIONS > SET STOW ELEV
4. Select Enter
5. Analyzer says "Calibrate Stow Elev Sensor?"
6. Select Enter
7. Analyzer will display "Complete"
8. Hit Escape to leave menu.
5.6 SERVICE MODE PROCEDURES
ECM Override (Dual Fuel Only)
This service menu may be utilized when ECM CAN
communication is lost on a machine equipped with
Dual Fuel, but Elevated Drive, Auto-Level, or Generator
function is needed. This service mode will bypass the
ECM CAN loss DTCs and allow the machine to function
as normal.
1. Using the Analyzer, navigate to SERVICE MODE >
ECM OVERRIDE.
2. Input the pass code 22954 and select Enter.
3. The Analyzer will display ALLOW FUNCTIONS?
4. Select Enter.
5. Analyzer will display FUNCTS ALLOWED.
6. Select Escape to leave menu.
Elevation Service
This procedure allows a service technician to elevate the
platform when an active DTC is preventing elevation by
bypassing the DTC and allowing the platform to lift up.
This mode remains active until a power cycle occurs.
Once power is cycled, the DTC will become active again,
and Elevation Service mode must be reactivated to lift.
1. Using the Analyzer, navigate to SERVICE MODE >
ELEV SERVICE.
2. Input the pass code 87189 and select Enter.
3. Select Enter to activate the Elevation Service Mode.
4. 4.Analyzer will display COMPLETE!
5. Elevation Service is now active. Select Escape to
leave menu.