JLG 530LRT, Service And Maintenance Manual

Page: 219 / 262

SECTION 5 - JLG CONTROL SYSTEM
3121781 5-23
5.7 MACHINE CONFIGURATION AND PROGRAMMING SETTINGS
The Machine Configuration Programming must be completed before any Personality settings (Table 5-5) can be
changed. Changing the Personality settings first and then changing the Model of the Machine Configuration will cause
the Personality settings to return to default values.
Table 5-3. Machine Configuration Programming Information
Configuration Digit Setting Description Default Number
MODEL NUMBER:
1
0
1
2
330 LRT
430 LRT
530 LRT 2
MARKET:
2
0
1
2
3
4
5
ANSI USA
ANSI EXPORT
CSA
CE
AUSTRALIA
KOREA
0
ENGINE:
3
0
1
2 KUBOTA T4F
KUBOTA T4I
KUBOTA D/F
0
GLOW PLUGS:
4
0
1
2
3
NO GLOW PLUGS
5 SEC GLOW
10 SEC GLOW
20 SEC GLOW 3
LEVELING JACKS:
5
0
1
No - Leveling Jacks not installed on vehicle.
YES - Leveling Jacks are installed on vehicle. 1
GENERATOR:
6
0
1
NO - Generator is not installed on vehicle.
YES - Generator is installed on vehicle.
0
LOAD SYSTEM:
7*
0
1
2
NOT INSTALLED – No overload detection.
CUTOUT PLT – Platform controls are disabled when overloaded.
CUTOUT ALL – Platform and Ground controls are disabled when overloaded.
NOTE: * Different Defaults by market: CE = 2
1
GROUND ALARM:
8*
0
1
2
NOT INSTALLED – Vehicle alarm will function for Overload (if LOAD enabled).
DESCENT – Vehicle alarm will function for Overload (if LOAD enabled) and during Lift Down
motion.
MOTION – Vehicle alarm will function for Overload (if LOAD enabled), during Drive
motion, and during Lift motion.
NOTE: * Different Defaults by market: CE = 0
2
ENGINE SHUTDOWN:
9
0
1
NO - The engine will not be automatically shutdown.
SHUTDOWN - The engine will automatically shutdown in the event of high engine
coolant temperature, low oil pressure, or a temperature sensor or oil pressure sen-
sor fault. 1
LOW TEMP CUTOUT:
10
0
1
NO - The machine will not have low temperature cutout functionality.
YES - The machine is equipped with low temperature cutout capability for the CE and ANSI
EXPORT markets.
0
BEACON LIGHT:
11*
0
1
NO - The beacon light will never flash except for when being used by Electronic Arm
Guards (CE market). See footnote.
YES - The beacon light will flash at 1 Hertz all the time the machine is powered and not being
used by Electronic Arm Guards (CE market). See footnote.
NOTE: * The beacon light will ALWAYS be used for unique visual indi-
cation (flash at 1 Hertz for 2 seconds, then off for 1 second) for
the Electronic Arm Guards feature (only equipped on CE mar-
ket) regardless of the BEACON LIGHT setting.
0