JLG 530LRT, Service And Maintenance Manual

Page: 78 / 262

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3-36 3121781
Front Axle Assembly (Oscillating)
REMOVAL
SUPPORT THE FRAME AND AXLE BEFORE ATTEMPTING ANY REMOVAL
AND/OR ASSEMBLY PROCEDURES.
1. Disable machine operation. Remove wheel and drive
assemblies.
2. Unplug the axle tilt sensor electrical connection.
3. Remove the bolt and pin keeper (5).
4. Push the axle pivot pin (1) out and remove the thrust
washer (4) and bearings (3).
5. Front axle (1) can now be moved away from the
frame.
ASSEMBLY
1. When installing the axle assembly, follow Removal
Steps in reverse.
2. If removed, shim the wear pad to achieve a maxi-
mum gap of 1/16 in. (1.5 mm) between the pad and
the axle machined surface.
NOTE: Apply Loctite® #242 to bolts (8) attaching wear pad
(6) to the frame.
• Oscillating Axle Tilt Sensor - (item 10) If this sensor
is not wired correctly or if you have the wrong part
number you will get CANBUS FAILURE - OSCILLATING
AXLE TILT SENSOR
1. Front Axle
2. Pivot Pin
3. Pivot Pin Bushing
4. Thrust Washer 5. Pin Keeper and Screw
6. Wear Pad
7. Wear Pad Shims 8. Hex Head Screws
9. Osc. Axle Tilt Sensor
Bracket
10. Osc. Axle Tilt Sensor
11. Spacers
12. Mounting Bolts/Wash-
ers/Nuts
Figure 3-29. Axle Assembly (Oscillating)
MAF03750
8
7
6
3
2
3
4
5
9
10
11
12
1