JLG 530LRT, Service And Maintenance Manual, Page: 53 / 262

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3121781 3-11
Cover Sub-Assembly
1. Using the disconnect rod, push o-ring (6F) into the
groove inside the cover cap (6B).
2. Place the o-ring (6G) onto the cover cap (6B) so that it
rests against the flange of the cover cap.
3. Insert disconnect rod (6E) into cover cap (6B ) .
4. Set cover (6A) on table, exterior side up. Place cover
cap (6B) onto cover (6A), aligning the pipe plug hole
in the cover cap over the pipe plug hole in the cover.
5. Place two of the cover cap bolts (6C) into any two
bolt holes that are 180° apart on the cover cap (6B)
and tighten bolts.
6. Using a torque wrench, apply 2.95 to 3.69 ft. lb. (4 to
5 Nm) of torque to both bolts (6C).