PAGE 65 of 89
EB0162 Rev 00
AuxEncPos
Displays the position of the auxiliary encoder
in counts when connected to the module.
When the auxiliary encoder is moved, this
number will change. When the encoder is
moved from its current position and then
back to that exact same position, this number
will also return to its original position.
EncPos
The position of the modules motor encoder
in counts.
6.3.6.3 Touch Calibration Screen
This option allows calibration of the touch screen. Typically, this should not
be necessary.
Touch the screen as the markers appear in the four corners of the screen.
TIP:
It is recommended that the markers be touched with a small object to
enhance the touch position accuracy during calibration.
The new calibration is stored immediately when the fourth marker is
pressed. The calibration utility exits and return to the
System Utilities
screen. To abort the calibration, the system power may be turned off
before the last marker is pressed.
Touch dots to calibrate
Fig. 122 - Touch calibration screen
