Jeti Duplex DC16, User Manual

Page: 10 / 109

computer radio control system
EN
2. 2.
A B
4.3.5. Transmitter Mode Switch
The DC-16 transmitter allows you to switch between Mode 1, 2, 3
and 4 stick configurations with just few simple steps. In order to do
some of these, the stick control assemblies will need to be swapped.
1. Switch-off the transmitter and remove the 10 screws that secure
the radio back cover. Next, remove the radio back cover.
Be sure to disconnect the transmitter battery pack
connector.
2. Disconnect the control stick assembly wires from the Tx board.
(3 wires X, Y, S)
3. Remove the stick assembly connecting wires from their holders.
It may be necessary to remove the screws securing the RF circuit
board to release the wire group.
2
3
4
4
4. Remove both machine installation screws for each of the
control stick assemblies.
5. Carefully remove both control stick assemblies. Gently pull in
5
6
X Y S
the desired smooth tension.
3. Reconnect transmitter battery pack and reinstall radio back
cover and cover screws.