computer radio control system
EN
7.3.3 General
The DC-16 transmitter is not only equipped with the assistants for
airplanes or helicopters, but it also has a „General“ assistant which
can be used to create just about any other type of model. If your
model cannot be assigned to the category of an airplane or
helicopter, select the general model. The following setup describes
the creation of a boat model. This process could also be used to
create a profile for any other land/water/air model craft. In this
example, the model is controlled by basic functions like throttle and
rudder as well as by extended functions like a motor sound
generator, lighting system, siren and a smoke generator. The first
three above mentioned functions are controlled proportionally and
the rest are non proportional.
Servo assignment to receiver channels:
1.
Motor
2.
Rudder
3.
Motor Sound Module
4.
Lighting System
5.
Siren Sound Module
6.
Smoke Module
Before creating a model make sure that you have setup the correct
transmitter mode in
„Main menu -> System -> Configuration ->
MODE 1-4“
. The basic, standardized, assignment of transmitter
inputs to flight controls are based upon this selection.
First it is necessary to first create a model in the transmitter and then
bind the DC-16 transmitter with the receiver which will control the
given model,
see chapter 8.4: Receiver->Binding.
1.
Switch-on the transmitter. In the main
display push the key
„menu“.
Select the
item
„Model“
and push the
„3D button“.
2.
Select the item
„New model“
and push
the
„3D button“.
3.
Enter the name of your model and press
„F5(OK)“
(Note: you must enter a model
name to proceed.)
Then select the model
type
„General“.
Confirm by pushing the
„F5(Next)“
button.
4.
The first item in the
„Basic Properties“
menu is the number of motors in the
model. In this example, this item will not be
edited and we will proceed to the second
item, which is how the motor needs to be
controlled – i.e. whether the motor turns
only one direction (Single) or both
3.
3.
directions (double). Edit the item
„Motor type“
by selecting
„Double direction“.
Press the
„F5(Next)“
button to confirm.
Summary of Contents for Duplex DC16
