Jeti Duplex DC16, User Manual

Page: 108 / 109

5. 5.
computer radio control system
EN
3. To edit the mix simply highlight the mix
and press the “F4 (Edit)” button to go into
the selected mix’s advanced menu.
a
b
c
d
e
a. Flight mode setting configuration
b. Curve type icon
c. Switch assignment for the spoiler mix function
d. Delay for the mix function deployment or retraction
e. Output travel settings for the individual servos
If your wing configuration has 4 flap surfaces and you only want the
outer flaps (the set furthest from the fuselage) to move with the
elevator with this mix then set the
„Mix Output“ for columns „S2“
and „S3“ to 0%. This setting will not allow the „S2“ or „S3“ flaps to
move with the elevator mix function.
12.14 Flaps Mix – Camber Control
This is another popular sailplane mix. This mix allows you to
effectively change the airfoil of your model‘s wing by combining the
flaps and ailerons to lower the trailing edge (under camber) of the
wing. This helps to lower your flight speeds during landings or while
soaring.
„Under camber“ is added to the wings when the flaps and
ailerons are deflected a little bit downward. Adding under-camber
means that the bottom surface of the wing becomes more concave.
To use this mix your wing configuration must be
„2Ail“ or higher.
You can either use a free mixer to set up this mix or you can use the
Butterfly mix. You can find the Butterfly menu in „Fine Tuning,
>Butterfly“.
a
d
e
c
a. Switch assignment for butterfly mix function
b. Delay for the mix function deployment or retraction
c. Flight mode setting configuration
d. Aileron servo travel settings
e. Flap servo travel settings
f. Elevator servo travel setting