Jeti Duplex DC16, User Manual

Page: 62 / 109

EN
computer radio control system
Trainer Mode with Two Jeti DS/DC-16 Radios
1. Make sure that the instructor’s transmitter is bound to the
aircraft in the “Default” wireless mode and that all flying
surfaces are functioning properly.
2. Change the instructor’s transmitter wireless mode to “Teacher”
and authorize the secondary TX module to bind with the
student’s transmitter.
3. Switch ON the student’s transmitter, change its wireless mode
to “Student” and allow the instructor’s transmitter to bind
properly. Verify that all of the aircraft’s surfaces are correctly
controlled by the student’s transmitter. If they are not correct,
make the necessary changes in the student’s transmitter.
Trainer Mode for Jeti DS/DC-16 as the Instructor Radio
Other brands of transmitters can be used by the student with a Jeti
Duplex EX 2.4GHz radio system by using a special wireless “Trainer”
communication module by Jeti.
1. Make sure that the instructor’s transmitter is bound to the
aircraft in the “Default” wireless mode and that all flying
surfaces are functioning properly.
2. Change the instructor’s transmitter wireless mode to “Teacher”
and authorize the secondary TX module to bind with the
student’s transmitter.
3. Connect the wireless trainer module to the student Tx “Trainer
Jack” (see Tx manual) then prepare the module for binding to
the instructor Tx by inserting the bind plug into the “Ext” port
(see the module guide)
4. Verify that all of the aircraft’s surfaces are correctly controlled by
the student’s transmitter. If they are not correct, make the
necessary changes in the student’s transmitter.
Trainer Mode for Jeti DS/DC-16 as Student Radio and Instructor
Radio is Different – Requires Special Trainer Module
1. Make sure that the instructor’s transmitter is bound to the
aircraft’s transceiver in the “Default” wireless mode and that all
flying surfaces are functioning properly.
2. Connect the wireless trainer module to the instructor Tx
“Trainer Jack” (see Tx manual) then prepare the module for
binding to the student Tx by inserting the bind plug into the
“Ext” port (see the module guide)
3. Switch ON the student’s transmitter, change its wireless mode
to “Student” and allow the instructor’s transmitter to bind
properly.
4. Verify that all of the aircraft’s surfaces are correctly controlled
by the student’s transmitter. If they are not correct, make the
necessary changes in the student’s transmitter.
Double Path Wireless Mode
a) Mode Selection.
b) Primary RF module bind control menu line
c) Secondary RF module bind control menu line