Jeti Duplex DC16, User Manual

Page: 13 / 109

computer radio control system
EN
4.4 Swappable and Assignable Switches .
One of the most important features of a Jeti transmitter is the switch
function assignment flexibility. The DC-16 transmitter automatically
detects the type of switch and assigns the selected function. The
following switch types are available:
•
2-position short or long switch
•
2-position spring-loaded long switch
•
3-position short or long switch
You may either swap the existing switches around or take advantage
of the optional accessories and create your own custom
configuration.
Factory Switch Configurations for the DC-16 Transmitter
Sa
- 2- position spring-loaded long switch
Sb - 3- position short switch
Sc - 2- position short switch
Sd - 2- position long switch
Se - 3- position short switch
Sf - 3- position short switch
Sg - 3- position long switch
Sh - 2- position short switch
Si - 2- position short switch
Sj - 3- position long switch
2. 2.
Installation and Configuration of Gimbals Switches
After the switch has been installed into the stick assembly you have
to re-configure and enable it in the transmitter software before it will
function properly. This can be done in the transmitter menu
„Main
menu->Advanced setup->Sticks/ switches setup“, see section
9.3.2.
14. Connect control stick assembly wires to the Tx board connector
(3 wires X, Y, S ). Pay close attention to the wire lengths. Connect
the longest wire as the first one from the outside of the
transmitter (3 connectors X, Y, S).
15. Secure the stick assembly wires into their holders.
16. Reconnect transmitter battery pack and reinstall radio back
cover and cover screws.