JETI model Duplex DS-16, Manual

Page: 105 / 164

computer radio control system
EN
f) Assignment for the input channel from the student’s
transmitter to the Control function of the instructor’s
transmitter.
g) The Trainer Mode allows you to directly assign an arbitrary
control (switch, stick even a logical switch) which will be ,
emulated for further use in the student's or teacher's
transmitter. The list of emulated inputs is located at the bottom
of the Function list. The behaviour depends on the mode
setting of transmitter:
1 ) Student mode . Here you can simply assign an arbitrary
control which will directly output its position/value to a
defined channel of the student's transmitter. In the picture,
the proportional control P8 is assigned to the seventh
channel. You can disable the output by un-checking the
"Enabled" button.
2 ) Teacher mode. Here you can decide which controls will
be emulated by any of the student's channels. At the
moment the student takes control of the model, the values
of these controls are fully overwritten by the values of the
appropriate student's channel. In the picture you can see
that channel seven emulates the proportional control P8
and thus all functions that rely on this control knob. With
this option, the student may switch the flight modes,
operate the Butterfly function directly etc.
Disable RF Transmission
You can manually disable the wireless transmission by pressing the
„ F1 button ” followed by a confirmation of the choice. The RF system
turns Off automatically when the USB connection is activated.
Caution: If you disable the transmission with a model attached ,
you may cause a signal loss alarm.
Trainer Mode with t wo JETI DS/DC Radios
Make sure that the instructor’s transmitter is bound to the 1.
aircraft in the “Default” wireless mode and that all flying
surfaces are functioning properly.
Change the instructor’s transmitter wireless mode to “Teacher” 2.
and authorize the secondary TX module to bind with the
student’s transmitter.
Switch ON the student’s transmitter, change its wireless mode 3.
to “Student” and allow the instructor’s transmitter to bind
properly. Verify that all of the aircraft’s surfaces are correctly
controlled by the student’s transmitter. If they are not correct,
make the necessary changes in the student’s transmitter.
Trainer Mode for JETI DS/DC as the Instructor Radio
Other brands of transmitters can be used by the student with a JETI
Duplex EX 2.4GHz radio system by using a special wireless “Trainer”
communication module by JETI.
4. 4.
104