JETI model Duplex DS-16, Manual

Page: 21 / 164

computer radio control system
EN
8
9
7
7
5. Carefully remove both control stick assemblies. Gently pull in
your direction (toward the transmitter back side).
6. Swap both stick unit assemblies and install them back into
correct positions.
After making a mode switch you must re-calibrate the
transmitter stick assemblies and setup the correct mode
in the software menu, see section 9.6.1 – Configuration.
The switch between Modes 1 to 3 or Modes 2 to 4 are
done with the software only (NO manual stick change is
necessary).
Note:
3.3.7 Transmitter Gimbals with Switch or Button
Installation
If you want to operate the DC-16 transmitter using the optional stick
end switch or button functions, you must purchase one or more of
these separately:
•
Stick with 2-position switch
•
Stick with 3-position switch
•
Stick with push-button
•
Stick with potenciometer
For installation of the optional gimbal stick ends with
switches/buttons we recommend that you send your
transmitter to one of the factory authorized service
centers or to your authorized dealer.
Advice:
X Y S
2. 2.
1. Switch off the transmitter and remove the 10 screws that secure
the radio back cover. Next, remove the radio back cover.
Be sure to disconnect the transmitter battery pack
connector.
It may be necessary to remove the screws securing the RF circuit
board to release the wire group.
4. Remove both machine installation screws for each of the
control stick assemblies.
5
6
7. Reinstall and secure the machine screws for each of the control
stick assemblies.
20