JETI model Duplex DS-16, Manual

Page: 42 / 164

computer radio control system
EN
4.9 Handling
2. 2.
4.8 PPM Input/Output Connector
The PPM output is accessible via connector labeled „B“. This
connector features the non-stabilized battery voltage output in the
range of 3.2V - 4.2V (max. 1A) which can be used as power supply for
the connected HF module as well as for the PPM signal output. The
transmitter output functions are in the form of a standard PPM
signal.
1. PPM input (3V logics)
2. Positive (+) pin
3. Negative (-) pin
4. PPM signal output (3V logics, configurable in
„ System->Configuration ” )
The DS-16 is equipped with a metal handle for practical
manipulation as shown in the picture.
Before each flying session, and especially with a
new model, it's important to perform a range
check. If you are operating a model with a DS-16
transmitter do not shield and avoid contact of the
transmitter antennas (see Photo)with your body.
Warning :
The transmitter antenna locations are shown in the picture below.
3
4
2
1
41