JETI model Duplex DS-16, Manual

Page: 86 / 164

computer radio control system
EN
Press the "F4 button" to display additional trim options. See picture
d) . You can store the currently highlighted trim (for example Ailerons
in the picture) to trim memory, or you can apply the trim memory
function to all trims.
How it works: The actual rate of the highlighted trim (or all trims,
respectively) is copied into a special register. (See the last colum of
picture ) . Once the rate is stored, the trim rate column value will be a)
cleared. This applies always to all flight modes. The trim memory
function is beneficial if you want your trims zeroed although some
offsets have been set. When processing, the transmitter sums the
actual trim rate and its stored value.
c)
d)
In the picture there are two more options available: Clear highlighted trim and Clear all d) ,
trims. After confirmation, this option clears the actual trim value (or all trim values,
respectively) and similarly zeroes the previously stored values (trim memory). This always
applies to all flight modes.
4. 4.
High Endpoint
Low Endpoint
Center
Centered mode Linear mode Throttle Low Throttle Lower 50% Throttle High
Center
Center
Center
Center
The Autotrim feature, when active, always influences the
model functions currently assigned to the particular trim
buttons (except for throttle function which is never affected by
this feature). The Autotrim function does not take effect on the
auxiliary incremental trims. Please be very careful if you
assign trim buttons to any function that is not controlled by a
spring centered stick. It is advised to disable the Autotrim
completely in such a case. Warning:
9.2.3 Flight Mode Trims
This menu allows you to set the function output position (if needed)
for each flight mode individually. For example: if your elevator
needs to be raised in one of your flight modes but not the others.
Each function output can be set either globally or separately.
1. Servo Position
A transmitter output channel can be assigned to more than one
receiver output channel if needed. Adjusting the values in the
individual columns marked
“S1-S4” will change the position of the
servo (surface) for each output function. The servo position is
displayed as a percentage of the total servo travel.
Pressing the
“F3 (Clr)” button resets the highlighted line’s travel
values to 0%.
Pressing the “F1 (Sym.)” turns ON/OFF the lock which allows each
output to be adjusted either together (symmetrically), or
independantly.
85