30 | BA-40100-02-V17
TOPAX
®
DX
Multichannel controller
19 Menu configuration and main settings
19.1 Menus of the TOPAX DX
In this chapter all of the TOPAX DX menus are presented and their op-
eration exemplified. As the display is in colour and high resolution, the
menus are shown in text and are clearly arranged.
19.1.1 Standard display
If there are no entries in the TOPAX DX within 5 minutes, the device
turns to the standard display.
mg/l
mV
ºC
comb. cl.
temp.
REDOX
disinfenction
pH value
7.04
0.39
719
mg/l
0.09
26.3
eff. cl.
0.30 mg/l
Topax DX
14:28 06.02.2007
Fig. 23: Standard display of TOPAX DX - with total chlorine measurement
The bars below the digits of the measured values indicate the strength
of the respective output signal. The colour of the display changes, de-
pends on the signal power, from green (0 – 85 %) to orange (85 – 95 %)
and rot (95 – 100 %).
Pressing any key takes you to the main menu (menu 1).
19.1.2 Menu 1 and 2: Main menu and sub-main menu
mg/l
mV
pH
mg/l
menu 2
trend
calibration
setpoint
ESC
status
039 702 719 09
0
main-menu
1
Fig. 24: Menu 1: The main menu of the TOPAX DX and starting point for
reaching all further sub-menus and their functions: With the displays for
①
Disinfection,
②
pH value and
③
Redox. Depending on the configuration,
④
indicates combined chlorine (mg/l), temperature (°C) or conductivity (%).
①
②
③ ④
Menu 2 acts as a sub-main menu:
mg/l
mV
pH
alarms
controller
ESC
039 702 719 09
0
menu 2
recorder
night mode
service
mg/l
2
Fig. 25: Menu 2: Extension of the main menu
You can access all other sub-menus through the main menu (menu 1)
and the sub-main menu (Menu 2).
Menu Key
Remarks for sub-menu
1
Main menu
ESC
Return to the standard display
1.1
Setpoints
Sets the setpoints of the configured controllers
1.2
Calibration
Calibration of all sensors connected to the system
1.3
Trend
Shows measurements as line chart in various
zoom stages
1.4.1
Status
Display of all important settings
2
Menu 2
Change to the following menus
2
Menu 2
ESC
Return to the main menu
2.1
Controller
Optimization of the parameters of all configured
controllers (access to this menu can be protected
by a password).
2.2
Alarms
Assigns the alarms to the measurement signals
2.3
Recorder
Sets the zooming function for the analog outputs
0/4 – 20 mA
2.4
Night oper-
ation
Selection auto switch ability and adjustment of the
new setpoint.
5
Services
Further adjustment options
(access to this menu can be protected by a
password):
• Configuration
• Inputs
• Auto setup
• Network
• Time
• Password
• DIN contact:
• Alarm settings
• Recorder
• Display
• Hardware status
(HW-Status)
• Outputs
• Reset
• Logbook
• Timer
• Service password
• Flocculation
• Start
• Digital inputs
• Language
Tab.: Overview of the sub-menus of TOPAX DX
On the following pages all sub-menus are presented in ascending order
and exemplified by means of a demonstrative example.
