IOM J500.32
Jerguson
®
LumaStar
™
2021.05
19
16633 Fol
tz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828
www.clark-
reliance.com ● [email protected]
8.2 Alternate Bracket
1. Align Jerguson
®
LumaStar
™ assembly with rear (side with bolt heads) of gauge. Loosen bracket thumb
nuts and adjust the position of the brackets to line up with their respective bolts on the gauge. Tighten
the thumb nuts to secure in place. When possible, use the 2
nd
set of bolts from the edge of the cover
plate. Note that all one-section size 7 models and smaller will require the power supply to be remote
mounted.
2. Align one side of the brackets as shown in Figure 16, so that the clip of the brackets are gripping around
the side of the gauge. Roll the entire assembly over until it is flush with the rear flat of the gauge and
press until the bracket clips have locked into place as shown in Figure 17.
Figure 15
Figure 16
Figure 17
